In Reply to: Oil pressure and temperature sending units posted by Figment on 04/07/03 at 1:31 PM:
Figment (sorry you didn't give your first name),
If necessary you can mount the oil sending unit remotely.
Replace the threaded nipple in the block with an 1/8" barbed nipple. Then run a length of high pressure hose (power steering hose is perfect) to a convenient location and mount the sending unit there. Don Moyer has a kit you can use part #FPMP_08_49 , Oil safety switch kit (for bulkhead mounting).
As far as the temperature gauge goes, there should be a fitting in the front-side of the head directly above the flywheel where the temperature sending unit should go.
Check out Don Moyer's website for a picture.
Good Luck!
Steve