carb rebuild


[ Follow Ups ] [ Return to Atomic 4 Bulletin Board ]
[ FAQ & WWWBoard Information ]

Posted by Mitch on September 18, 2003 at 09:24:15:

Hello all-
I just purchased a Westerbeke/Universal carb rebuild kit from for my aluminum A-4 carb. It came with an assortment of gaskets, needle valve, etc. What I can't figure out is the four rubber bushing thingies that were included. Are these intended to replace the packing where the choke and throttle assemblies shafts pass through the wall of the carb? If so, how exactly do they fit into the counterbore, in what order, facing what direction?
Thanks for the help.
-mitch


Follow Ups:




[ Follow Ups ] [ Return to Atomic 4 Bulletin Board ]
[ FAQ & WWWBoard Information ]